P0AE0 BMW Fault Code
Check P0AE0 OBD Fault Code ReasonFuel Rail Pressure Sensor in Range But Low The comprehensive component monitor (CCM) monitors the FRP pressure for acceptable fuel pressure. The test fails when the fuel pressure falls below a calibrated value.
Low fuel pressure Damaged BMW FRP sensor Excessive resistance in circuit Low or no fuel A FRP PID value below 551 kpa (80 psi) indicates a failure Low or no fuel A FRP PID value greater than 896 kpa (130 psi) indicates a failure.
P0AE0 Code Symptoms :
There are currently two main types of cylinder deactivation used today, depending on the type of engine. P0AE0 code for the pushrod design which uses solenoids to alter the oil pressure delivered to the lifters. In their collapsed state, the lifters are unable to elevate their companion pushrods under the valve rocker arms, resulting in valves that cannot be actuated and remain closed.
Diagnosis And Repairing P0AE0
P0AE0 OBD 2 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.
How to fix P0AE0 code ?
- 1Camshaft Position Sensor circuit poor electrical connection
- Faulty spark plug (s)
- Faulty Mass Air Flow (MAF) sensor
- Variable Camshaft Timing (VCT) position circuit poor electrical connection
To check for an open circuit, trace along the length of the transmission control circuit, checking for breaks in the wiring. Repair any broken wiring and make sure all connectors are fully seated and locked.
Pay close attention to connectors, looking for corrosion, bent or broken pins, or moisture in the connector. Repair any connector issues even if they are not specifically part of the transmission control circuit as they may serve a function in providing power to the transmission control circuit.
